Product Specifications 

TKD1 Drawer

• Dimensions: 435 x 1040 x 245mm
• Drawer in: 490 x 1105 x 300mm
• Drawer out: 490 x 1900 x 300mm
• Weight: 44kg

TKD2 Drawer

• Dimensions: 925 x 1040 x 145mm
• Drawer in: 980 x 1105 x 200mm
• Drawer out: 980 x 1905 x 200mm
• Weight: 63kg

TKD3 Drawer

• Dimensions: 435 x 1040 x 435mm
• Drawer in: 490 x 1105 x 490mm
• Drawer out: 490 x 1905 x 490mm
• Weight: 58kg

The post Armorgard Van Storage Drawers appeared first on Vanwagen.

The Handeman Xtra provides a minimum of fifteen 12 second hand washes per filling – enough for a hard day’s work – providing hot water with fingertip tap operation.

The standard Handeman Xtra is fully automatic and only powers up when the battery is fully charged and the engine is running, so there is no drain on the battery.

The Handeman Xtra is provided in 12 and 24 volt versions.

Van hand wash sinks are breaking new ground in cost saving and hand hygiene for the commercial vehicle operator. Handeman Xtra mobile sinks for motor vehicles are the perfect solution for those that need a hot water hand wash on the move.

Available in four versions (see below), it simply connects to the vehicle’s electricity supply, ensuring hot water is always to hand. No plumbing is required. The Handeman Xtra for motor vehicles is supplied in a practical 2 tone grey colour.

The Handeman Xtra for motor vehicles conforms to ECE Regulation 10 and EC Directive 72/245.

All Handeman Xtra models have the unique ‘Waste-safe’ that retains all the dirty water without the need for separate waste pipe or waste water storage container.

Small yet practical
The Handeman Xtra provides a minimum of fifteen 12 second hand washes per filling – enough for hard day’s work – providing hot water with fingertip tap operation. It has a unique jet spray that reaches every part of the hands and washing under running water means there’s no need to dip hands into dirty suds.

Built to last
Robustly constructed in hi-impact polyethylene and designed to stand up to the rough and tumble of on the road use.

Hot water hand washing benefits from an ideal water temperature of just over 40°C.

Also available as a special order – the Handeman Xtra HMX12LW low wattage unit comes fitted with a 90 watt heater.

The Handeman is robust enough to fit inside or outside the vehicle. Supplied with a complete fitting kit and full instructions together with the correct fuse and fuse holder. A 4mm (35amp) cable needed to connect directly to the battery terminals.

Euro 6 compliant wiring and control

Teal vehicle units incorporate 3 wire technology. Standard battery positive – red wire, earth wire – black. The white wire is to be connected to the ignition control fuse.

Standard HMX12

• When the vehicle is turned off, the battery state is quiescent at 12V.
• When switched on, the ignition control wire detects vehicle turned on. The voltage sensing software will turn the heater on when 12.6 volts are detected. Thereafter the heater will be monitored by the built in thermistor and control the water temperature at 40-43°C. When the vehicle is switched off the unit will switch off having sensed the battery voltage has dropped to 12.3V and the ignition signal has been dropped.
• The battery will not be therefore be drained by the Handeman.

Standard HMX24

• When the vehicle is turned off the battery state is quiescent at 24V.
• When switched on the ignition control wire detects vehicle turned on. The voltage sensing software will turn the heater on when 25.6 volts are detected. Thereafter the heater will be monitored by the built in thermistor and control the water temperature at 40-43°C. When the vehicle is switched off the unit will switch off having sensed the battery voltage has dropped to 25.1V and the ignition signal has been dropped.
• The battery will not be therefore be drained by the Handeman.

For a quotation or advice on this product, please contact us on 01733 852828 or email us at sales@vanwagen.co.uk

The post Handeman Xtra for motor vehicles appeared first on Vanwagen.

This Kit Comprises Of:

Full Height Side Panels In 6mm Plywood (Depending On Make/Model).

Side Loading Door Top And Bottom Panels In 6mm Plywood(Depending On Make/Model).

Rear Door Top And Bottom Panels in 6mm Plywood(Depending On Make/Model).

Floor supplied in 9mm Plywood.  Or for an extra cost upgrade to 12mm Plywood or 12mm birch Wisadeck (Phenolic)

Fully Assembled Wheel Arch Covers In 9mm Plywood.

Tube Of Silicone Sealant.

All Fixings.

Full Set Of Fitting Instructions.

——————————————————————————————————————————————————

Information we require to give you a quotation

1. Make ?
2. Full Model ?
3. Full Registration Number?
4. Vehicle Length ? (e.g. Swb, Mwb, Lwb, Xlwb,  L1, L2, L3, L4, XS, Compact, M, Standard)
5. Height ? (e.g. Low Roof, Medium Roof, High Roof, H1, H2, H3)
6. How Many Sliding Doors Does Your Van Have? (e.g. 1 or 2)
7. What Side Are The Sliding Doors? (e.g. N/S Passenger Side or O/S Drivers Side or Both)
8. Rear Door Configuration? (e.g. Rear Doors Solid, Rear Doors With Windows, Tailgate Solid, Tailgate With Window)
9. What Drive? (e.g. FWD, Front Wheel Drive, RWD, Rear Wheel Drive, AWD, All Wheel Drive)
10. Panel Van or Crew Van?

———————————————————————————————————————————————————

We can arrange free delivery within the mainland UK (excl. Northern Ireland, Channel Islands, Scottish Highlands and Offshore Locations).

Plywood lining kits delivered to the UK only (Europe delivery is not available)

We do not offer free delivery to the following postcodes and due to additional costs may charge extra for the following post codes HA, IV, KA, KW, PAand PH.

If a customer orders from a postcode area incurring an extra delivery charge, the customer will be contacted by phone or email and given the option to pay any extra charges or cancel the order.

Customers will be responsible for the carriage/delivery cost of all returns. The cost for these postcodes is £45 + VAT.

DELIVERY SCHEDULE

We aim to dispatch all orders within 3 to 5 working days (excl. weekends and bank holidays) for stock items. Expected delivery dates or times given by Vanwagen Limited , our suppliers, or our carriers are given as a guide only. We cannot be held liable for any losses or costs incurred from delivery at a different date or time.

All images/pictures are for illustration purposes only.

For a quotation or advice on this product, please contact us on 01733 852828 or email us at sales@vanwagen.co.uk

The post Plywood Lining Kits Delivered appeared first on Vanwagen.

The post HDD Seat Covers Fiat Talento Driver & Single Passenger Seat 2017+ appeared first on Vanwagen.

The post HDD Seat Covers Ford Ranger Driver, Single Passenger & Rear Triple Seat 2016+ appeared first on Vanwagen.

The post HDD Seat Covers Ford Transit Driver & Dual Passenger Seat 2014 + appeared first on Vanwagen.